Home/Silk fabrics/Silk Chiffon Fabric

FABRIC FAMILY · Sheer · 100% MULBERRY SILK

Silk Chiffon Fabric

The lightest silk we weave — six momme of almost nothing, with a soft twist that keeps it from clinging.

Momme
6–16 mm
Weight
≈ 26–69 gsm
Width
114 / 140 cm
Availability
Ready stock

Silk chiffon is a sheer, plain-weave mulberry silk woven from tightly twisted yarns at a low sett. At 6 mm it weighs about 26 gsm, which is close to the practical limit of a woven silk — it moves in the faintest air and layers without adding bulk.

It is the fabric of veils, overlays, scarf hems and gathered sleeves. The twist means it does not cling the way a flat filament chiffon does, and it takes dye to soft, even, slightly dusty tones that read as expensive rather than bright.

At a glance

  • 6 mm / ≈26 gsm — the lightest standard silk weight
  • Twisted yarn gives a dry hand, so it floats instead of sticking to the skin
  • Sheer: needs a lining, a slip or a deliberate double layer
  • Prints beautifully for scarves — soft edges, no glare

How Silk Chiffon is woven

Structure: Plain weave, high twist, open sett

Interlacing diagram — warp ends vertical, weft picks horizontal. A dark cell is a point where the warp passes over the weft.

warp over weftweft over warp

Chiffon is a plain weave with hard-twisted yarns set at a low density, so the cloth is sheer and holds air. The high twist is what keeps an open structure stable — without it the yarns would simply slide past each other and the fabric would distort in the hand.

Because the structure is open, chiffon has little body of its own and gains weight and opacity only through layering or lining. It is also the most slippery silk to cut: pin inside the seam allowance and consider cutting between tissue paper.

Understanding the structure is the cheapest way to predict behaviour: the length of the float decides the lustre and the snag resistance, and the twist in the yarn decides how much the cloth creases. If you are choosing between two families, the weight chart and the fabric selector filter on both.

Weights we weave — and what each one is for

Momme fixes the price, the opacity and the drape. The table below is the range we actually quote for Silk Chiffon. The exact weight and width are confirmed in writing on every quotation.

MommeApprox. gsmWhat it is forQualities
6 mm≈ 26 gsmVeil, overlay and scarf weight — near-weightless6 mm Chiffon
8 mm≈ 34 gsmVeil, overlay and scarf weight — near-weightless6 mm Chiffon
12 mm≈ 52 gsmDouble-layer chiffon: enough body for a blouse or a soft dress12 mm Double-layer Chiffon
14 mm≈ 60 gsmDouble-layer chiffon: enough body for a blouse or a soft dress12 mm Double-layer Chiffon
16 mm≈ 69 gsmDouble-layer chiffon: enough body for a blouse or a soft dress12 mm Double-layer Chiffon

Not sure which weight you need? The momme chart converts every weight to gsm and matches each band to the garments it serves, and the selector filters the whole library by weight and application.

What Silk Chiffon Fabric is used for

Typical applications in this family are bridal veils, dress overlays, floaty sleeves, scarves, lingerie layers, stage costume, gathered skirts over a lining. Each link opens the buying guide for that application, with the weight windows we recommend and the fabrics our clients actually order.

Silk Chiffon Fabric vs Silk Georgette

Both are sheer and twisted. Georgette is denser and grainier with more bounce; chiffon is smoother, softer and lighter. If the cloth has to hold a gather, georgette; if it has to float, chiffon. Read the Silk Georgette guide.

Cutting and sewing this weight

Silk is not difficult to sew, but it punishes the wrong needle. The parameters below are the ones our clients converge on for this weight band; test on an offcut first, because a needle size that is fine for one finish will pick threads in another.

ParameterWhat we recommend for 6–16 mm (≈ 26–69 gsm)
Machine needle65/9 or 70/10
Stitch length12–14 stitches per inch (2.0–2.5 mm)
ThreadFine mercerised cotton, silk-finished polyester, or spun silk — matched to the shell so the seam does not pucker
Interlining / support15–25 gsm weft-insertion or a silk organza self-facing
Pressingsilk setting (around 110–130 °C), reverse side, pressing cloth
Pre-shrinkingcold soak 10–15 minutes, or thorough steam; dry flat
Seam finishFrench or hairline seam on anything sheer; overlocked and turned on opaque weights
  • Cut single layer. Silk shifts, and a folded lay gives you two panels that are not mirror images.
  • Pin inside the seam allowance only, with fine glass-head or silk pins — a pin hole through charmeuse or a satin face is permanent.
  • Use a fine, well-twisted thread. A thick thread in a fine needle leaves a visible channel and puckers the seam.
  • Mark the straight grain on every panel before you lift it off the table. On a bias-cut garment the grain line is the whole design.
  • French seams or hairline seams on anything sheer: a plain turned seam shows as a dark line through the cloth.

How much silk chiffon to order

Planning quantities, from standard block patterns. Figures are for a plain layout with no pattern repeat to match.

Garment or itemAt 114 cm widthAt 140 cm widthNotes
Scarf 90 × 90 cm1.0 m1.0 mIncludes a narrow hand-rolled hem; allow more for a wide hem or a border print
Camisole or shell top1.2 m1.0 mBias cut; add 15% if the design is cut on the true bias
Blouse or shirt2.0 m1.6 mStraight body, set-in sleeve; more for a gathered or oversized body
A-line skirt1.5 m1.2 mAbove-knee; a full circle skirt needs roughly double
Straight dress2.8 m2.2 mKnee length, no train, bodice and skirt from one length
Bias slip dress3.2 m2.6 mBias layouts waste more; buy the length the pattern states, not the flat measure
Evening gown with train5.5 m4.5 mFloor length; fitted bodice plus a trained skirt needs a second length to match
Standard pillowcase 50 × 70 cm0.7 m0.7 mEnvelope closure; pair two if the fabric has a directional nap
Curtain panel, 2× fullness—3.0 m per metre of dropRule of thumb: drop × 2 to 2.5 for pencil pleat, plus hem and heading allowance

These are planning figures from standard block patterns, not a cutting guarantee. They assume no pattern matching and no nap. Add 10–15% for a large repeat or a one-direction print, and add your shrinkage allowance before you order. If a program is costing on metres, send us the marker and we will quote against the actual consumption.

What to check before you cut

Every roll is inspected before dispatch, but cloth is a natural product and dye lots vary. These are the eight checks worth making at goods-in — they take two minutes and they are the difference between a claim and a write-off.

CheckHow to do itWhat is a problem
Shading, side-to-side and end-to-endLay the cloth folded end to end and across the width under daylight or a D65 lamp.Any visible step between the centre and the selvedge, or between the start and the end of a roll.
Bowing and skewingSquare the cloth on a table and measure the diagonal, or check a printed repeat against the selvedge.The weft running more than a few centimetres off square across the width — it distorts every panel cut from it.
Slubs, thick and thin placesExpected and structural in dupioni and shantung; check for consistency across panels.A slub count that varies sharply between panels of the same garment.
Broken ends, floats, snagged yarnsHold the cloth up to a light source and scan across the width.Any broken filament on a satin face — it will run under tension.
Crease marks and chafe marksUnroll flat and look across the surface at a low angle.Permanent creases pressed into a finish, or abraded lines where the roll has rubbed in transit.
Soiling, oil and water marksScan both sides; some marks only show on the reverse.Any spot. Silk stains cannot be safely spot-cleaned before dyeing.
Width short against the ticketMeasure the usable width between the selvedges, excluding the pin-holes.Less usable width than the quotation states — markers are often drawn tight.
Hand and finish against the approved sampleCompare to the bulk sample you signed off, in the same lighting.A softer or firmer hand, or a difference in lustre. Finishing drifts between dye lots.

Every roll we ship is inspected before it leaves, and any piece with a defect is cut short and the metrage credited rather than passed on. Even so, check the cloth before it goes under the knife: once a piece is cut it is accepted. Report anything within seven days of delivery with the roll number.

Ordering: minimums, colours and finishing

Stock colours are available from 1 metre, which makes sampling practical. Custom dyeing starts at 40 metres per colour with a lab dip approved before bulk; digital printing starts at 40 metres per design after a strike-off. Widths are 114 / 140 cm, and the momme tolerance is stated on the quotation rather than assumed.

For a production program, approve a one-metre cut in the bulk colour before the roll is dyed — screen colour and cloth colour are not the same thing, and silk chiffon fabric is a family where a shade difference shows across a seam.

Care and handling

Hand wash cold with a pH-neutral silk detergent, or dry clean. Do not soak or wring; roll in a towel and dry flat away from direct sun. Press on the reverse with a cool iron through a cloth. Expect 3–5% shrinkage on the first wash, so pre-shrink before cutting a production run.

Frequently asked questions

Is silk chiffon see-through?

Yes. At 6 mm it is genuinely sheer and needs a lining, a slip or a second layer for anything worn against the body. At 12 mm (double-layer chiffon) it is still translucent but far more forgiving.

What is the difference between silk chiffon and polyester chiffon?

Silk chiffon is 100% mulberry silk: it breathes, takes dye deeply, has a dry rather than slick hand, and does not build static. Polyester chiffon is cheaper, glossier, holds a crease permanently and does not breathe — the two are easy to tell apart by touch and by burn test.

How much does silk chiffon cost?

6 mm chiffon is one of the least expensive real silks per metre because it uses very little raw material; 12 mm roughly doubles the price. Quotations depend on colour, width and quantity — ask for a quote against your order.

Can silk chiffon be sewn on a normal machine?

Yes, with a fine needle (60/8), a straight stitch on a strip of tissue paper, and a French seam or rolled hem. It shifts under the presser foot, so light pressure and a walking foot help more than any special technique.

How do I know this is real mulberry silk and not polyester satin?

Ask for a burn test on a cutting: mulberry silk burns slowly, smells like burning hair, and leaves a brittle black bead that crushes to powder. Polyester melts, smells sweet-acrid and leaves a hard bead. We supply 100% mulberry silk and state the composition on every quotation; if you need formal confirmation we can arrange third-party fibre analysis on the bulk.

What width do the rolls come in, and can I get a wider one?

Standard widths are 114 cm and 140 cm, and the usable width excludes the selvedge. Wider widths are woven to order on a minimum quantity. If a marker needs a specific width, tell us before quoting — the price is calculated on the width as well as the weight.

How much shrinkage should I allow?

Silk typically relaxes 3–8% on the first wet treatment, more on washed finishes and less on a fabric that has already been sand-washed. The safe approach is to pre-shrink a full length before cutting a production run, or to have the piece steam-shrunk. Do not guess: the allowance belongs in the marker, not in the pattern.

Can you match a colour I send you?

Yes. Send a physical swatch or a Pantone reference and we dye a lab dip for approval before bulk. Custom colours start at 40 metres per colour. Screen and monitor colours are not a reliable reference — a photograph of a fabric is two colour conversions away from the cloth.

What is the lead time?

Stock colours dispatch in a few working days. Dyed-to-order runs need the lab dip approved first, then dyeing and finishing; printed runs need a strike-off approved before bulk. The quotation carries the confirmed date for your quantity, and we would rather quote a longer date and meet it.

Do you ship samples, and can I order just one metre?

Yes. Stock colours are available from one metre so you can test drape, dye uptake and washing before committing. We post swatch cards worldwide; tell us which families you are comparing and we will send the relevant colours.

PHOTOGRAPHED FROM OUR STOCK

Silk Chiffon — the cloth, as it is

Unretouched photographs of rolls and cut lengths from our own floor. Colour varies between dye lots; the swatch card is the only reliable reference.

Other silk fabric families

Shop by application

Order silk chiffon fabric swatches

One metre, any stock colour, posted worldwide. Tell us the weight and we will send the closest match from the shelf.

BUYING QUESTIONS

Buying questions

Minimums, lead times, colour approval and what the price is made of.

SILK WEIGHTS IN DETAIL

One page per weight

What we actually weave at each weight — the families, the qualities, what it suits and how it sews.